cistron írta:

> Elég kis kéz kell hozzá

Ezt találtam a neten:

------------

Mazda 6 Low Beam Install

Installing low beams on a Mazda 6 is actually very easy and will take about 15 minutes with hand tools (a dental mirror helps alot). Don't ask about high beams, getting to those looks really hairy!

First pop the hood -obviously. The low beams on a 6 are the outermost lights in the lamp assembly.

Before you go and try to get to the bulbs disconnect the battery terminals, remove the fuse box cover and unbolt the square coolant tank on the passenger side of the car and move it off to the side.

DO NOT disconnect any of the hoses on the coolant tank or try to remove it from the car, just put it to the side.

Now you've got room to get your hands into where they need to go. You'll notice that there is a circular plastic cover on the housing behind the low beams. These each will unscrew and pop off. Once you take these off it is a simple matter of removing and replacing the low beam bulb.

The bulb is held in by a metal latch. It is a wire that looks like a loop off a paper clip. disconnect by just push down and inwards (toward the middle of the car) on it and it'll pop up. Pivot it up out of the way and the bulb will pull right out. (actually, they both push towards the left if you are standing in front of the car looking at the headlights)

Replace the bulb and make sure you note how the old bulb was installed as it will only go back in one way. ALSO make sure you do not touch the bulb itself as the oil from your skin will cause the bulb to have hot spots and burn out sooner.

Reverse the process for the install making sure you get the metal tabs to latch in properly and make sure you secure the circular covers back onto the headlight housing. Also make sure you securely reattach the coolant tank and put the fuse box cover back on.