// relay8_Demo
// Copyright (C)2015 Rinky-Dink Electronics, Henning Karlsen. All right reserved
// web: http://www.RinkyDinkElectronics.com/
//
// A quick demo of most of the library functions.
//

// Include our library :)
#include <relay8.h>

// Declare what pins our relays are connected to.
// relay8 supports from 1 to 8 relays.
relay8 relay(2, 3, 4, 5, 6, 7, 8, 9);

void setup()
{
// Nothing special is needed here
}

void loop()
{
// Switch the first relay on and off a couple of times
for (int t=0; t<3; t++)
{
relay.on(1);
delay(500);
relay.off(1);
delay(500);
}

// Switch the last relay on and off a couple of times
for (int t=0; t<3; t++)
{
relay.on(relay.numberOfRelays());
delay(500);
relay.off(relay.numberOfRelays());
delay(500);
}

// Switch all relays on and off a couple of times
for (int t=0; t<3; t++)
{
relay.allOn();
delay(500);
relay.allOff();
delay(500);
}

// Cycle through all relays slowly from the first to the last
// then a little faster back down again
for (int t=0; t<3; t++)
{
relay.cycleUp();
relay.cycleDown(100);
}

// Switch on all relays in sequence then switch then all off
// again a little faster
for (int t=0; t<3; t++)
{
relay.chaseUpOn(500);
relay.chaseUpOff();
}

// Switch on all relays in sequence then switch then all off
// again a little faster. This time in the opposite direction
for (int t=0; t<3; t++)
{
relay.chaseDownOn();
relay.chaseDownOff(100);
}
}