/*
SD card read/write

This example shows how to read and write data to and from an SD card file
The circuit:
* SD card attached to SPI bus as follows:
** MOSI - pin 11
** MISO - pin 12
** CLK - pin 13
** CS - pin 4 (for MKRZero SD: SDCARD_SS_PIN)

created Nov 2010
by David A. Mellis
modified 9 Apr 2012
by Tom Igoe

This example code is in the public domain.

*/

#include <SPI.h>
#include <SD.h>

File myFile;

void setup() {
// Open serial communications and wait for port to open:
Serial.begin(9600);
while (!Serial) {
; // wait for serial port to connect. Needed for native USB port only
}

Serial.print("Initializing SD card...");

if (!SD.begin(53)) {
Serial.println("initialization failed!");
return;
}
Serial.println("initialization done.");

// open the file. note that only one file can be open at a time,
// so you have to close this one before opening another.
myFile = SD.open("datalog.csv", FILE_WRITE);

// if the file opened okay, write to it:
if (myFile) {
Serial.print("Writing to datalog.csv...");
myFile.println("testing 1, 2, 3.");
// close the file:
myFile.close();
Serial.println("done.");
} else {
// if the file didn't open, print an error:
Serial.println("error opening datalog.csv");
}

// re-open the file for reading:
myFile = SD.open("datalog.csv");
if (myFile) {
Serial.println("datalog.csv:");

// read from the file until there's nothing else in it:
while (myFile.available()) {
Serial.write(myFile.read());
}
// close the file:
myFile.close();
} else {
// if the file didn't open, print an error:
Serial.println("error opening datalog.csv");
}
}

void loop() {
// nothing happens after setup
}