Egy dolog, ami lehet, hogy érdekes: (bocs, kicsit hosszú)
Volkswagen RNS 510 Firmware Upgrade to version 2840 / 2844 / 2846 / 2848
Version 2840 / 2844 / 2846 / 2848 Firmware for the Volkswagen RNS 510 and the Skoda Columbus has been released. This is the final 2xxx release, future releases are 3xxx – Volkswagen RNS 510 – 3xxx Firmware Changes.
- Voice Control (requires microphone – see Volkswagen RNS 510 Microphone Connection for voice control)
- Speed Limit Display
- Stability Improvements
- Faster Startup (this has been improved on 2760)
- Display OPS and RVC at the same time
- SDHC 32 GB Support (HW04 and above)
- Display Off on extras tab
- Climatronic control if approriate climatronic fitted
- Clock display if RNS 510 swtiched off (buggy)
- Excluded roads (under route options)
- GPS coordinates entry
- Additional adjustments for video
- Larger RVC screen with transparent menus at the side
Units that can be upgraded include (still being compiled may not be 100%)
- 1T0 035 680 C (1T0035680 C) from software version 1000, 800, 900, 1100 and 2660 to version 2700.
- 7L6 035 680 C (7L6035680C) from software version 1002, 1022, 1102 and 2664 to version 2700.
- 3T0 035 680 A (3T0035680A) to version 2704.
- 7F0 035 680 (7F0035680) to version 2700.
- 7E0 035 680 (7E0035680) to version 2700.
- Further to follow as the firmware is loaded.
Download the files and extract them using winrar and you will have a NRG format ISO file to burn. Using Nero burn a DVD+RW or DVD-R (CDR works as well) at a slow speed (4 x is ok for DVD and 16 x for CD). Make sure you use quality media and keep the burn speed down as low as you can to ensure there are no problems during the installation process. Also note that you may need to edit a file before you burn it (see below) if you want to access the setup menu without Vagcom/VCDS.
Warning! This upgrade WILL delete your music and/or maps if you have a firmware version PRIOR to version 1100/1102. Units with a firmware version of 1100/1102 will not have music and maps deleted.
Warning! 7L6 Touareg RNS 510′s are no longer supported since version 2760 due to the Touareg being fitted with the RNS 850. Version 1200 was the last version factory loaded on the 7L6 units with a hardware revision B.
Warning! There is a remote chance of you ‘bricking’ the unit, this is a fraction of a percent but it could happen! The process takes around 60 minutes.’
Warning! There are a small number of users where the RNS 510 does not know where it is after it’s been powered on, details of the previous location are kept in the unit but at this stage there is no pattern to this problem.
Warning! Users with cars MY07 and earlier may experience power drain issues after the upgrade. See the post “Upgrading 2nd generation radios (RCD 300, RCD 500) to 3rd generation (RCD 210, RCD 310, RNS 310, RCD 510) power drain issue” for more details.
Warning! Users with the Skoda UHV bluetooth 1Z0 035 729 B (1Z0035729B) may want to delay upgrading the firmware, there is an issue with the RNS 510 no longer displaying the phone book and/or the call details but signal strength etc are visible for some phones. My HTC Diamond for example worked fine before the update but only partially afterwards however my Iphone 3G worked fine before and after. This is not a problem with the 1Z0 035 729 D (1Z0035729D) Skoda UHV bluetooth kit. The MFD functions as per normal with phone book and last calls listed correctly. Android 2.1 phones work fine with the update.
Note! - Test/Setup Mode. The firmware can allow access to enter test/setup mode without Vagcom/VCDS access see Accessing the Setup Menu on the RNS 510 head units with firmware later than 1100. The procedure for entering the test/setup mode for those with Vagcom/VCDS is slightly different as well. To enter the test/setup mode when the RNS 510 is operating press and hold the setup button, keep holding it when the radio menu appears and shortly after the test menu appears . I had to reboot my unit after coding it but it may be possible a power cycle is enough.
Note! - Failure (Gateway Error 202) - You can downgrade back to 1100 by inserting the 1100 firmware and rebooting the RNS 510 (Setup + eject + info).
Steps to load firmware
- Unlock and/or open the car
- Do not start the car and do not insert the key in the ignition
- Turn the RNS 510 on and insert the firmware CD/DVD into the drive
Download Firmware Upgrade
Download Location
File 1: No download links available yet, please contact us if you have valid links.
File 2:
File 3:
File 4:
Download Unofficial SWL recovery CD
This is used if the unit is stuck with Gateway Error 202 or similar and is unable to boot after the upgrade. It’s based on the 272x firmware but can be used to recover RNS 510′s running any version. Insert the media into the RNS 510 and start a new SWL process by pressing Setup + Eject +Info/Mic (top right hand button next to the DVD slot). It will attempt to restore a new SWL process and will enable it to boot up. (Thanks again to Josi)
Download Location
File: http://www.megaupload.com/?d=TG9ZATDY
Version Information from VERSION.TXT
Közélet
